Trademark Filing
Diageo North America, Inc.
Trademark Applicants & Owners
| Owner: |  Diageo North America, Inc. |
| Address | 175 Greenwich Street 3 World Trade Center New York CT 10007 |
| Legal Entity Type | Corporation |
| Legal Entity State | CT |
Documents
Click the blue "Refresh" button to load certificates, specimines, application, and other documents.
Design Search Codes
| 190902 | Bottles, jars or flasks with bulging, protruding or rounded sides; Flasks with bulging or protruding sides; Jars with bulging or protruding sides |
Attorney of Record
Good, Services, and Codes
| International Codes: | 33 |
| U.S. Codes: | 049,047 |
| Type Code | Type |
|---|---|
| DM0000 | The mark consists of a three-dimensional configuration of a bottle for the goods. The bottle has wide shoulders that flare out just below the neck. The sides of the bottle then curve inward toward the center of the bottle, and flare out at the bottom of the bottle. The bottle is octagonal in shape, with the central front and rear surfaces of the bottle wider than the sides. The shape of the central front surface of the bottle follows the shape of the sides of the bottle, with a curved top, and sides that flare out at the top and bottom and curve inward at the center. The central front surface is flanked on each side by a plane which meets the central surface at an angle. Each plane features an etched diamond pattern that begins just below the shoulders of the bottle and runs down the length of each side of the bottle, with slightly larger diamond shapes at the shoulders than the sides. The base of the bottle is composed of smooth, thin planes, one of which is beneath the central front surface and two of which are beneath the diamond-etched planes. The bottom of the bottle is raised in the center, and the raised section is visible in a frontal view of the bottle. The bottom of the stopper is round, while the remainder of the stopper is octagonal. The octagonal portion of the stopper is divided into three segments - the bottom segment flares out at a curved angle, the middle segment has flat sides, and the top segment flares back in. A series of indented vertical lines are etched into the bottom and top segments of the octagonal portion of the stopper; the surface of the middle segment is smooth. |
Trademark Filing History
| Description | Date | Event Coding |
|---|---|---|
| NEW APPLICATION ENTERED | 2024-04-10 | 1 NWAP I:Incoming Correspondence |
| NEW APPLICATION OFFICE SUPPLIED DATA ENTERED | 2024-05-29 | 2 NWOS I:Incoming Correspondence |
| NOTICE OF DESIGN SEARCH CODE E-MAILED | 2024-05-29 | 3 MDSC E:E-Mail |
uspto.report is an independent third-party trademark research tool that is not affiliated, endorsed, or sponsored by the United States Patent and Trademark Office (USPTO) or any other governmental organization. The information provided by uspto.report is based on publicly available data at the time of writing and is intended for informational purposes only.
While we strive to provide accurate and up-to-date information, we do not guarantee the accuracy, completeness, reliability, or suitability of the information displayed on this site. The use of this site is at your own risk. Any reliance you place on such information is therefore strictly at your own risk.
All official trademark data, including owner information, should be verified by visiting the official USPTO website at www.uspto.gov. This site is not intended to replace professional legal advice and should not be used as a substitute for consulting with a legal professional who is knowledgeable about trademark law.
| 