Examiners Amendment

ARROWHEAD

Arrowhead Products, Incorporated

Examiners Amendment

UNITED STATES PATENT AND TRADEMARK OFFICE

UNITED STATES PATENT AND TRADEMARK OFFICE

 

    SERIAL NO: 76/458454

 

    APPLICANT:         Arrowhead Products, Incorporated

 

      

 

       

 

    CORRESPONDENT ADDRESS:

ROBERT W. GUTENKAUF

PO BOX 2906

MINNEAPOLIS MN 55402-0906

 

 

RETURN ADDRESS: 

Commissioner for Trademarks

2900 Crystal Drive

Arlington, VA 22202-3514

ecom115@uspto.gov

 

 

If no fees are enclosed, the address should include the words "Box Responses - No Fee."

    MARK:          ARROWHEAD

 

 

 

    CORRESPONDENT’S REFERENCE/DOCKET NO:   88864(E32.22

 

    CORRESPONDENT EMAIL ADDRESS: 

 612-333-0066

Please provide in all correspondence:

 

1.  Filing date, serial number, mark and

     applicant's name.

2.  Date of this Office Action.

3.  Examining Attorney's name and

     Law Office number.

4.  Your telephone number and email address.

 

 

Serial Number  76/458454

 

 

EXAMINER’S AMENDMENT

 

In accordance with the authorization granted by Robert W. Gutenkauf on May 13, 2003, the application has been AMENDED as indicated below.  Please note that if the identification of goods or services has been amended below, any future amendments must be in accordance with 37 C.F.R. 2.71(a); TMEP section 1402.07(e).  No response is necessary unless there is an objection to the amendment.  If there is an objection to the amendment, the applicant should notify the examining attorney immediately.

 

The examining attorney has searched the Office records and has found no similar registered or pending mark which would bar registration under Trademark Act Section 2(d), 15 U.S.C. §1052(d).  TMEP §704.02.

 

AMENDMENT OF IDENTIFICATION OF GOODS

 

The identification of goods is amended to read as follows:

 

Metal building materials, namely, metal soffits, metal fascia, metal gutters and metal downspouts, and related metal accessories, namely, metal gutter coil, metal outside and inside mitre sections, metal outside and inside strip mitre, metal end caps, metal joint connectors, metal downspout holders, metal pipe band and roof aprons for gutters, metal frieze trim, metal drip caps and roof drip edges for soffits, metal corner post caps, metal corner substrate, metal “j” channels, metal “f” channels, metal undersill trim, and, metal starter strips;  metal siding, in International Class 6.

 

 

 

/Michael Souders/

Trademark Attorney

Law Office 115

ecom115@uspto.gov

(703) 308-9115 ext. 208

 


uspto.report is an independent third-party trademark research tool that is not affiliated, endorsed, or sponsored by the United States Patent and Trademark Office (USPTO) or any other governmental organization. The information provided by uspto.report is based on publicly available data at the time of writing and is intended for informational purposes only.

While we strive to provide accurate and up-to-date information, we do not guarantee the accuracy, completeness, reliability, or suitability of the information displayed on this site. The use of this site is at your own risk. Any reliance you place on such information is therefore strictly at your own risk.

All official trademark data, including owner information, should be verified by visiting the official USPTO website at www.uspto.gov. This site is not intended to replace professional legal advice and should not be used as a substitute for consulting with a legal professional who is knowledgeable about trademark law.

© 2024 USPTO.report | Privacy Policy | Resources | RSS Feed of Trademarks | Trademark Filings Twitter Feed